Priming evercare® inLine, monoset

In these recommendations you will find guidance on how to prime evercare® inline monoset with needle free connector.

Step 1

Unwrap the set. Close the clamp on side tubing, make sure the air vent is closed.

Step 2

Stick the side spike through the membrane into drug vial.

Step 3

Open the air vent on the side tubing.

Step 4

(A) Fill the drug vial by holding up the infusion bag and open the side clamp. Fill the drug vial half full, close the clamp or (B) attach a syringe to the needle free connector, fill the drug vial half full.

Step 6

To minimize a blocked filter: never infuse fluid into vial when inverted and never shake the vial when inverted.

Step 7

Close the air vent. Shake the vial side to side until the substance is dissolved.

Step 8

Open the air vent. Turn the drug vial upside down and raise it over the level of the infusion bag. Open the side clamp.

Step 9

When the drug is transferred to the infusion bag, close the clamp and the air vent. Leave the empty bottle on the side tubing.

Please note!

! See the package for complete IFU instructions for use, this is only a guide for users !

DO NOT OVER-TIGHTEN connections. DO NOT USE any instruments to tighten connections.

Our products

10515-01, 10516-02, 10517-02, 10518-02, 10576-01, 10583-02

How to prime evercare® inLine, mono/duo set

Customer service: +46 770 111 115

The user creation failed because the invitation could not be sent. If the problem continues then please contact customer support.

An error occurred while processing your request. Please contact customer support if the problem continues.

A connection error occurred. Check your connection and try again.

Invitations was not sent for the following emails:

Already active

Wrong file format

The selected file is either empty or holds invalid content

The selected file is too large. Maximum allowed file size:

Failed to retrieve all prices. Please try again later.

You have to Accept the User terms to proceed