Priming evercare® inLine, vented with bottle

In these recommendations you will find guidance on how to prime evercare® inLine infusion set with bottle.
1
InLine vented with bottle - step 1

Step 1

Unwrap the IV-set and check whether the air vent cap is closed and the roller clamp is open. Important: Do not open the air vent!
2
InLine vented with bottle - step 2

Step 2

Change position of the roller clamp and control that the tubing is unaffected and close it.
3
InLine vented with bottle - step 3

Step 3

Place the bottle on a surface and spike the membrane. Hang the bottle on a IV pole or similar. Keep the air vent closed!
4
InLine vented with bottle - step 4

Step 4

Attach the tubing to the tube holder at the roller clamp.
5
InLine vented with bottle - step 5

Step 5

Squeeze gently the drip chamber 3-5 times to fill half of the drip chamber (too aggressive squeeze can lead to mixed air fluid below the drip chamber).
6
InLine vented with bottle - step 6

Step 6

Open the roller clamp until the complete tubing is primed. Keep the air vent closed!
7
InLine vented with bottle - step 7

Step 7

Closed the roller camp.
8
InLine vented with bottle - step 8

Step 8

After priming, open the air vent.

Additional information

Here you can find related products and PDF for download.


Products

REF: 10499, 10500-01, 10502-01, 10570-01, 10504-01, 10506-01, 10577-01, 10578-01, 10579-01, 10580-01, 10581-01, 10582-02, 10585-02, 10700, 10702, 10703, 10704, 10705, 10706, 10707, 10708, 10709, 10710, 10711, 10712.

 

Download PDF

Please note!

See the package for complete IFU instructions for use, this is only a guide for users

DO NOT OVER-TIGHTEN connections. DO NOT USE any instruments to tighten connections

Tip: Glass and non fully collapsible containers: Keep the vent closed during spiking and priming. Only open the vent flap when venting is required.

Step-by-Step Video Guide


© Copyright 2026 Evercare Medical. All Rights Reserved.